Samson DOUBLE BRAID Class II Eye Splice Modified for Turb Uživatelský manuál stáhnout pdf (Strana 3)

PAGE 3 OF 5

SamsonRope.com | Email [email protected] | Tel +1.360.384.4669

Double Braid Class II Eye Splice Modiﬁed for Turbo-37

SAMSON SPLICING INSTRUCTIONS

step

GROUPING AND TUCKING COVER

DIVIDING COVER INTO 6 BUNDLES

step

Slide

excess cover

Cover divided into

6 groups

tape

Cover divided into 6 groups

(3 per eye cover end)

Splice base

cover strand bundles

Eye cover

strand bundles

Put the rope under tension

and slide the cover from the

base of the splice back up the

rope towards the splice area.

It will be necessary to unbraid

the end of the cover for some

length in order to remove all

the slack from the braided

section. Slide past the braided

section as far as possible up

past the end of the splice.

Then tightly tape the braided

cover at the point where the

braid begins to come apart

and divide the unbraided cover

yarns into 6 separate bundles.

Finally divide the unbraided

cover yarns from the eye into

6 separate bundles (3 bundles

from each leg of the eye.)

Starting at the base of the splice, take 1 of the 6 cover braid bundles, pass it over 1 of the cores and under the very next core (forming

a simple tuck similar to that used in splicing 3-strand rope.) When tucking the cover bundle be careful not to go under the core in the

center of the rope. Repeat this procedure with each of the 6 cover bundles. The direction of the tucks should be as shown.

When all 6 bundles have been tucked once, tightly tape around the rope at the point where the tucks occur. Repeat this procedure until

a minimum of 3 complete tucks have been made with all 6 cover bundles. Additional tucks can be made if there is sufcient length left.

When the last set of tucks has been made and taped, cut off the excess cover yarn bundles ush with the last taped section.

Cut ends off at angle

3 sets of tucks minimum

Standing side

Tail side

Figure H

step

SPLICING BOTTOM 3 CORES

Turn the rope over and repeat Step 6 using the

last 3 cores and core tails. Core tail #5 passes

over core #5 and #6 and tucks into core #7. Core

tail #6 passes under core #5 and tucks into #6.

Core tail #7 tucks directly into core #5 (Fig. H).

1 2 3 4 5

Komentáře k této Příručce

Žádné komentáře

Samson DOUBLE BRAID Class II Eye Splice Modified for Turb Uživatelský manuál Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Nástroje Samson DOUBLE BRAID Class II Eye Splice Modified for Turb