Samson DOUBLE BRAID Class II Eye Splice Modified for Turb Uživatelský manuál stáhnout pdf (Strana 4)

PAGE 4 OF 5

SamsonRope.com | Email [email protected] | Tel +1.360.384.4669

Double Braid Class II Eye Splice Modiﬁed for Turbo-37

SAMSON SPLICING INSTRUCTIONS

TUCKING EYE COVER BUNDLES

Next, tuck the 6 cover braid yarn bundles at the base of the eye. With the eye laying at (as shown in Fig. I) take bundle closest to the

throat of the eye (bundle #1) and pass it under core A. Take the next cover yarn bundle (#2) and pass it under core B. Take core bundle

#3 and pass it under core C.

step

To be tucked on other

side of rope

Cut ends off at angle

3 sets of tucks minimum

Tape exposed splice for the entire length

Turn rope

over

Figure I

Figure J

Turn the rope over and continue this process with the 3 remaining cover yarn bundles (Fig. J). The direction of the tucks should be

as shown. Tape around the rope at the point where the tucks occur. Repeat this procedure until a minimum of 3 tucks have been

completed. When the last set of tucks has been made and taped, cut off excess cover yarn bundles ush with the last taped section.

step

Slide the cover material (which was put on the rope in Step 3) up over the exposed

cores. At the eye-end of the splice, separate the strands of the cover material into 4

equal size bundles (2 on the top of the rope and 2 on the bottom.)

Top of rope

2 legs

of the eye

Slide cover material over

exposed cores

tape

FINISHING THE SPLICE

1 2 3 4 5

Žádné komentáře

Samson DOUBLE BRAID Class II Eye Splice Modified for Turb Uživatelský manuál Strana 4