Samson MPL 1502 Specifikace stáhnout pdf (Strana 21)

Using Equalization

One of the most exciting aspects of using a mixer such as the MPL 1502 is the

ability to shape a sound, using a process called equalization. But there are few

areas of sound engineering more misunderstood than equalization, and, just as

good EQ can really help a sound, bad EQ can really hurt it, so read on...

Every naturally occurring sound consists of a broad range of pitches, or

frequencies, combined together in a unique way. This blend is what gives every

sound its distinctive tonal color. The EQ section in a mixer allows you to alter a

sound by boosting or attenuating specific frequency areas. The MPL 1502

provides independent three-band equalization controls for each of its five mono

and five stereo input channels. Each EQ knob is labeled with the maximum

amount of cut or boost provided (± 15 dB in the case of the high and low

frequencies and ± 12 dB in the case of the middle frequency).

We provided these particular frequency areas because they have maximum

impact on musical signals—that’s why they are sometimes known as “sweet

spots.” When an EQ knob is in its center detented position (“0”), it is having no

effect. When it is moved right of center, the particular frequency area is being

boosted; when it is moved left of center, the frequency area is being attenuated.

The high EQ control employs what is known as a

shelving curve, where only

frequencies above the specified area are affected. The low and mid frequency

controls employ what is known as a

peaking resonant curve (sometimes known

as a bell curve), where frequencies both above and below the specified area are

affected.

In most instances, the best way to approach equalization is to think in terms of

which frequency areas you need to attenuate, as opposed to which ones you

need to boost (boosting a frequency area also has the effect of boosting the

overall signal; too much EQ boost can actually cause overload—with the

accompanying Peak LED warning!). Be aware of the phenomenon of

masking,

where loud sounds in one frequency range obscure softer sounds in the same

range; by cutting EQ “notches” in a loud signal, you can actually make room for a

softer one to shine through. And try not to think of EQ as a miracle worker—no

amount of equalization can put a singer in tune or remove the distortion from an

overloaded input signal! The key is to get the signal right in the first place, by

using correct gain structure and mic placement.

Although the specific EQ you will apply to a signal is very much a matter of

personal taste, here are a few general suggestions: Boosting the low frequency

of instruments such as bass drums or bass guitar will add warmth and make the

sound “fatter”; conversely, you may want to attenuate the low frequency compo-

nent of instruments such as cymbals, high-hats, and shakers so as to “thin” them

out. The mid-range control is particularly effective for vocals—attenuating it can

give a vocal performance more of an “FM-radio” feel, while boosting it can help a

vocal cut through dense instrumentation. Be careful not to boost high frequen-

cies too much or you risk adding hiss to the signal, though just a touch can help

add “shimmer” to an acoustic guitar, ride cymbal, or high-hat. Finally, because

the MPL 1502 high EQ utilizes a shelving curve, attenuated settings can be used

to reduce hiss (which is composed almost exclusively of high frequencies).

HIGH

-15 +15

MID

-15 +15

LOW

-15 +15

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře

Samson MPL 1502 Specifikace Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Směšovače zvuku Samson MPL 1502