Samson S2000 Provozní pokyny stáhnout pdf (Strana 69)

Press , Code 36 blinks

Turn

→

Std

Press . All start-up parameters and the di

-

agnosis are reset to their default values.

Note:

–

Code 36 - diAG allows just the diagnosis

data (EXPERTplus) to be reset. Refer to

EB 8389 EN on EXPERTplus valve diag

-

nostics.

–

Reset the control and identification pa

-

rameters as well as the bus address with

the FACTORY_RESET parameter (refer to

Configuration Manual KH 8384-4 EN).

7.9 Start-up via local interface

(SSP)

The positioner can either be commissioned,

configured, and operated on site, using the

Fieldbus configuration or operating system,

or TROVIS-VIEW operator interface con

-

nected over the serial interface in the

positioner.

Use the TROVIS-VIEW software with 3730-4

device module installed.

To connect the positioner directly to the PC

via the local serial interface, an adapter (or

-

der no. 1400-7700) is required.

The positioner can be supplied with power

by connecting it to a fieldbus segment or

over a DC voltage source (9 to 32 V) con

-

nected to the bus terminals in the positioner.

The simultaneous operation of

TROVIS-VIEW and the fieldbus system is

possible without any restrictions when con

-

nected to a PROFIBUS-PA segment.

7.10 Setting the bus address

A maximum of 32 positioners in a safe

(non-hazardous) area can be operated over

a segment coupler in one PROFIBUS-PA seg

-

ment.

Each positioner connected in the segment

must be assigned a unique bus address be

-

tween 0 and 125.

Default 126

Turn

→

Code 3, display: No

Press , Code 3 blinks.

Change the setting of Code 3.

Turn

→

YES

Press , display:

The configuration is enabled.

Turn

→

Code

46, press ,

turn

→

required address,

press 10 seconds

→

The address is

adopted straightaway, provided that cyclic

data exchange is not taking place.

During the cyclic data exchange, the newly

set address for the positioner is saved and

adopted after the cyclic data exchange is

finished.

The newly assigned address is indicated un

-

der Code 46 in alternating sequence with

the current address. The new address is

marked with “n“ (new) and the currently

used address with “o“ (old).

EB 8384-4 EN 69

Start-up – Settings

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 123 124

Komentáře k této Příručce

Žádné komentáře